Please read these instructions carefully. Fill the valves in number 0rder #1-#2.
Be careful not to over inflate. Fill until the wrinkles are smoothed out.
  1. #1-#2 Valve.
  (#1 Valve for inner tube.)
  2. Inflation order: #1- #2.
     Filling Valve #1-#2:


1) Install the #A connector
to the pump.

 2) Insert the Blower
 end into the valve
 completely then start to
 inflate. 		3) Once fully inflated, close
the valve immediately.
Make sure the valve is
closed completely.
4) Press down the valve
until the stem is pushed in.


   5) Done.

           Special Notes:
           (1) For best standing results, all 4 legs (#1 valves) should be fully inflated have same pressure.
           (2) Make sure all valves are closed properly to ensure that there is no air coming out.
     
Fuzhou Jetsonic Light Industry Co., Ltd. www.jetsonic.com
E-mail:Service@jetsonic.com TEL:+86-(0)591-83628233 FAX:+86-(0)591-83624729