Please read these instructions carefully. Be careful not to over inflate. Fill until the wrinkles are smoothed out .
	1.      1#----Valve.   2.      2#----Rope holder.
Filling Valve #1:
1) Install the #A connector         to the pump.		2) Insert the pump end   into the valve completely   then start to inflate.			3) Once fully inflated, close  the valve immediately.  Make sure the valve is  closed completely.	4) Press down the valve  until the stem is pushed in.			5) Done.
Special Notes:   *Make sure all valves are closed properly to ensure that there is no air coming out.

Fuzhou Jetsonic Light Industry Co., Ltd. www.jetsonic.com
E-mail:Service@jetsonic.com TEL:+86-(0)591-83628233 FAX:+86-(0)591-83624729