Please read these instructions carefully. Fill the valves in number 0rder #1-#3. Be careful not to over inflate. Fill until the wrinkles are smoothed out.
	1. #1- #2- #3--- Valve.      2. Inflation order: #1- #2- #3.
Filling Valve #1- #2:
1) Install the #B connector      to the pump.	2) Insert the pump end     into the valve completely     then start to inflate.		3) Once fully inflated, close   the valve immediately.   Make sure the valve is   closed completely.		4) Press down the valve    until the stem is pushed in.		5) Done.
Filling Valve #3:
1) Install the #A connector      to the pump.	2) Insert the pump end    into the valve completely    then start to inflate.		3) Once fully inflated, close    the valve immediately.    Make sure the valve is    closed completely.		4) Press down the valve    until the stem is pushed in.		5) Done.
Special Notes:   *Make sure all valves are closed properly to ensure that there is no air coming out.

Fuzhou Jetsonic Light Industry Co., Ltd. www.jetsonic.com
E-mail:Service@jetsonic.com TEL:+86-(0)591-83628233 FAX:+86-(0)591-83624729