Please read these instructions carefully. Fill the valves in number order #1 - #5.
Be careful not to over inflate. Fill until the wrinkles are smoothed out .

 

 
1. #1 - #2- #3 - #4 - #5 Valve.
    (#1 - #2 Valve for inner tube.)

2. Inflation order:  #1 - #5
    Filling Valves #1- #4:  
1) Use fingers to squeeze valve as shown, so that it opens the internal flap of the valve for inflation. 2) Place blower end to the valve and begin filling. 3) Once fully inflated, close the valve immediately. Make sure the valve is closed completely. 4) Press down the valve until the stem is pushed in. 5) Done.
    Filling Valve #5:  
1) Install the #A connector to the pump. 2) Insert the Blower end into the valve completely then start to inflate. 3) Once fully inflated, close the valve immediately. Make sure the valve is closed completely. 4) Press down the valve until the stem is pushed in. 5) Done.
  Special Notes:
(1) For best standing results, all 4 legs (#1 and #2 valves ) should be fully inflated have same pressure.
(2) Make sure all valves are closed properly to ensure that there is no air coming out. 		 
 
 
Fuzhou Jetsonic Light Industry Co., Ltd. www.jetsonic.com
E-mail:Service@jetsonic.com TEL:+86-(0)591-83628233 FAX:+86-(0)591-83624729