Please read these instructions carefully.

 
       Repair Instruction
1) This is the special repair patch. Glue side up is marked with the Jet logo. 2) Before repair, clean the affected area thoroughly to remove any dirt and debris.

3) Cut a piece of the repair patch so that it will surround the affected area by at least 2 inches.

4) Mark and draw along the hole on the repair patch. The marking should be at the center of the sheet.
5.1) Small Holes (pinhole size)-Cut repair patch and place glue side down on the affected area. 5.2) Medium Holes (small rips)-Cut proper sized repair patch then place on the inside of the item glue side up. 5.3) For large hole, follow step 5.2 and place a second repair patch on top of the affected area with glue side down. There are now 2 pieces, one inside and the other outside. 6) Make sure that the repair area is smoothed out and there are no folds in the repair patch or the affected area, then cover with a cotton sheet.
7) Place iron over the cotton sheet in the repair area and hold for 30 seconds. Iron temperature should be set around 230-248 Fahrenheit or silk/cotton settings. 8) Let the area cool down, then check if the repair patch is sealed firmly onto the affected area. Repeat Step 6 and 7 if needed. 9) Make sure that the repair patch has bonded completely with the item. 10) Your repair is now finished.
Fuzhou Jetsonic Light Industry Co., Ltd. www.jetsonic.com
E-mail:Service@jetsonic.com TEL:+86-(0)591-83628233 FAX:+86-(0)591-83624729